Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

Register Log in
  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Din 1629 ST52.0 Pipe design Stress

Status
Not open for further replies.
KevinNZ

KevinNZ

Mechanical
Joined
Jun 12, 2003
Messages
879
Location
NZ
Hi

Does anyone know what design stress to use for Din 1629 ST52.0 pipe?

What is the equivant ASTM pipe?

Cheers
 
Sort by date Sort by votes
thanks Leonard

I found the same page. Where did you find the refernce to A587?

Cheers
Kevin
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

aiwa7777
  • Locked
  • Question Question
Membrane Stress
Replies
2
Views
2K
aiwa7777
aiwa7777
IdanPV
  • Question Question
Allowable Stress in ASME B31.1 - Table A-3
Replies
0
Views
4K
IdanPV
IdanPV
YuJie_PV
  • Question Question
ratcheting: The loading results in only primary stresses without any cyclic secondary stress
Replies
4
Views
5K
YuJie_PV
YuJie_PV
engineer0
  • Question Question
ASME B31.8 vs 49 CFR 192 Subpart D - Design of Pipeline Components
Replies
1
Views
8K
A.egis
A.egis
jayinwww
  • Question Question
Calculating Stress Ratio ASME B31.3 Figure 323.2.2A Note 6
Replies
0
Views
510
jayinwww
jayinwww

Part and Inventory Search

Sponsor

Back
Top