iamuwere
Automotive
- Oct 20, 2003
- 6
I drive a small formula car in SCCA competition. Top speeds of mid 130's with good flat cornering. We are allowed a flat bottom (55" width through the sidepods) with no more than a 1" deviation in height across the floor pan. Area before the front axle and after the rear axle are free. The obvious area to work with is the rear diffuser design.
I not yet found any good rules for diffuser design. Currently there is about a 10deg rise over approx 24" length. One center strake (straight) with straigt side plates.
Any good rules on diffuser design or good references with practical application?
Thanks,
jim
I not yet found any good rules for diffuser design. Currently there is about a 10deg rise over approx 24" length. One center strake (straight) with straigt side plates.
Any good rules on diffuser design or good references with practical application?
Thanks,
jim