beachcomber
Mechanical
Hello all,
I have a section view that has been rotated 90° clockwise.
From that I have an independant detail view with a non-circular border.
When I place the view the detail is correctly aligned but the border is rotated by 90° clockwise and hence the view is incorrectly cropped.
This does not happen with a standard (non-independant)detail view.
Can anyone confirm this behaviour.
ST1, MP12.
bc.
2.4GHz Core2 Quad, 4GB RAM,
Quadro FX4600.
Where would we be without sat-nav?
I have a section view that has been rotated 90° clockwise.
From that I have an independant detail view with a non-circular border.
When I place the view the detail is correctly aligned but the border is rotated by 90° clockwise and hence the view is incorrectly cropped.
This does not happen with a standard (non-independant)detail view.
Can anyone confirm this behaviour.
ST1, MP12.
bc.
2.4GHz Core2 Quad, 4GB RAM,
Quadro FX4600.
Where would we be without sat-nav?