Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Datum target ring

Status
Not open for further replies.

mfg11eng11guy

Mechanical
Joined
Jun 20, 2014
Messages
31
Location
US
I have a part with a large surface, but I do not want to whole surface to be the datum, but just a "Ring" shape, which consists of an outer diameter and inner diameter. Can this be done with datum targets?
 
Yes


John Acosta, GDTP Senior Level
Manufacturing Engineering Tech
SSG, U.S. Army
Taji, Iraq OIF II
 
Yes -- on the print/model you need to show the outer diameter and the inner diameter of your ring area (usually as basic dimensions), and then cross-hatch the annular area. Label it as a single target (A1, or whatever). Also be sure to locate the center from other datums that it will be used in conjunction with.

John-Paul Belanger
Certified Sr. GD&T Professional
Geometric Learning Systems
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top