Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
D1.1 Visual Inspection
- Thread starter novot
- Start date
We are writing a specification to have a fabricator manufacture a 14 gauge stainless steel (type 316) bracket to support our secondary vault lids. This bracket will require one 3/8” stainless steel hex nut (type 316) welded to the bracket to support damaged URD boxes.
Is there a CSA standard applicable to the above welding? Some articles reference the AWS/AMSE for the welding of the two metals, however I question the referencing since I’m unable to view the documentation.
Should there be precautions adhered to prevent corrosion or fatigue of the metal when welding?
Would be grateful for any specific guidance you may offer.
Is there a CSA standard applicable to the above welding? Some articles reference the AWS/AMSE for the welding of the two metals, however I question the referencing since I’m unable to view the documentation.
Should there be precautions adhered to prevent corrosion or fatigue of the metal when welding?
Would be grateful for any specific guidance you may offer.
- Status
Similar threads
- Locked
- Question