btcoutermash
Industrial
When you add a custom profile for a tapped hole to the hole wizard custom data base, how do you get the callout to show on the print when you use "Add a hole callout" command??
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Custom Hole wizard profiles
- Thread starter btcoutermash
- Start date
- Status
SPR 231247 - Thread type, depth, and size is missing from hole callut for derived standards.
Till this is fixed you have to do it manually.
FYI - You did place the data in your "Thread data" DB and not just under Hole wizard... didn't you?
Regards,
Scott Baugh, CSWP![[pc2]](/data/assets/smilies/pc2.gif "[pc2] [pc2]")
If you are in the SW Forum Check out the FAQ section
To make the Best of Eng-Tips Forums FAQ731-376
Till this is fixed you have to do it manually.
FYI - You did place the data in your "Thread data" DB and not just under Hole wizard... didn't you?
Regards,
Scott Baugh, CSWP
If you are in the SW Forum Check out the FAQ section
To make the Best of Eng-Tips Forums FAQ731-376
- Thread starter
- #3
btcoutermash
Industrial
Yes i did place the info in "thread data".
Then see the above SPR.
Regards,
Scott Baugh, CSWP
If you are in the SW Forum Check out the FAQ section
To make the Best of Eng-Tips Forums FAQ731-376
Regards,
Scott Baugh, CSWP
If you are in the SW Forum Check out the FAQ section
To make the Best of Eng-Tips Forums FAQ731-376
- Status
Similar threads
- Question
- Locked
- Question