Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Custom Electric Motor

Status
Not open for further replies.

idd

Mechanical
Joined
May 13, 2002
Messages
9
Location
US
I need a 1/4hp, 3 phase motor with a gear cut on the end of the shaft. It needs to be a C frame, preferably 48C or smaller as the device it will attach to is only 4 inches in diameter. I am not having any luck finding anything even close. ANY SUGGESTIONS WOULD BE APPRIECIATED.
 
Thanks for the suggestions! I thanks jbartos is right, it will have to be a custom. I was going for the long shot for off the self.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top