Creating New Command - Please Help (NX10)

[Cid1979]

I want to create a new button/command that will allow me to pick my target and then able to wave link a body into it, that's just the first part of it, secondly once it's in there, I want it to trim the piece and then delete the trim piece.

I know it will have to use the wave link function, then trim, and then delete body commands, I am just not sure on how to go about setting this up, do I use a journal or macro? I am not new at NX but I have never coded before. Any help or point me in the right direction would be awesome, I would like to start learning how to code.

 

[JohnRBaker]

Before I spent a lot of time with perhaps journals or maybe even NX Open, I would first look at the 'Product Interface' functionality of NX. You can find information about it in the NX Help files and in the software by searching on "Product Interface".

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.