Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Creating moving loads with API 1
- Thread starter dvdrr2000
- Start date
- Thread starter
- #3
Hello osquro, and thank you for your answer. On monday I will post some code to see it. Here, at home,, I haven´t the SAP installed.
I saw the next:
When you work with the SAP2000 windows interface to create a moving load analysis case you follow the next steps:
1.Create lane
2.Create vehicle
3.Create vehicle class
4.Create moving load analysis case, with the lane and vehicles defined
Instead, in API, the steps are not the same:
1.Create moving load analysis case
2.Create lane and assign to an existing moving load analyisis case
3.Create vehicles and assign to lane and moving load analysis case
I think that these two ways are not compatible. Wait for answers
PD: osquro, do you know what your nickname means in spanish? I think so...
I saw the next:
When you work with the SAP2000 windows interface to create a moving load analysis case you follow the next steps:
1.Create lane
2.Create vehicle
3.Create vehicle class
4.Create moving load analysis case, with the lane and vehicles defined
Instead, in API, the steps are not the same:
1.Create moving load analysis case
2.Create lane and assign to an existing moving load analyisis case
3.Create vehicles and assign to lane and moving load analysis case
I think that these two ways are not compatible. Wait for answers
PD: osquro, do you know what your nickname means in spanish? I think so...
- Thread starter
- #4
-
1
- Thread starter
- #5
- Status
Similar threads
- Question
- Question
- Locked
- Question