ewans
Mechanical
- Mar 24, 2004
- 30
Morning all,
Hoping for some input/feedback on whether or not an orthogonal datum axis feature can be used to constrain the rotation of a primary datum axis. I can't find an example of this scenario in Y14.5-2009 or in any other online resources. The closest reference I could find was section 4.16.8 in Y14.5-2009, but I would have an orthogonal hole in lieu of the slot.
I have attached a PDF drawing of this scenario, and was seeking to confirm if the established A,B datum reference frame is valid.
Additionally, any input/feedback on the application of projected tolerance zone, and the use of a minor thread diameter to establish datum feature C, would be most appreciated.
Many thanks.
Regards,
Ewan
Hoping for some input/feedback on whether or not an orthogonal datum axis feature can be used to constrain the rotation of a primary datum axis. I can't find an example of this scenario in Y14.5-2009 or in any other online resources. The closest reference I could find was section 4.16.8 in Y14.5-2009, but I would have an orthogonal hole in lieu of the slot.
I have attached a PDF drawing of this scenario, and was seeking to confirm if the established A,B datum reference frame is valid.
Additionally, any input/feedback on the application of projected tolerance zone, and the use of a minor thread diameter to establish datum feature C, would be most appreciated.
Many thanks.
Regards,
Ewan