CompactLogix: how to change the IP in MSG? SSV?

[rssql]

I have a CompactLogix L32E.
I want to use the MSG instruction with more than one IP address.
so, i need to change the IP address/path in the MSG.
I haven't been able to find an example.

Would i use SSV?

 

[jde777]

here you go...

http://rockwellautomation.custhelp....nBfc2VhcmNoX3RleHQ9Mjc5MTc*&p_li=&p_topview=1

 

[rssql]

Thanks,
I want to leave the IP of the Eth port as is.
I just want to change which device i communicate with.

 

[jde777]

http://rockwellautomation.custhelp....nBfc2VhcmNoX3RleHQ9MTc1MjE*&p_li=&p_topview=1

i can give you an example acd, but how do i upload to this site?

 

[ADMIRALKEN]

Simple solution:
Use two or more message instructions, one for each target device.

 

[rssql]

I can't create one MSG for each destination.
That could end up being 50 to 100 IP's.

thanks,