COLOR

[proengineer]

Dear pro\e users,

Can i have instances of a part in different colors? Amish Bhushan Goel
Engineer
Hitech e Soft
amg@hitechesoft.com

 

[hoyle]

I think quite a few have tried this, and the answer is no
If anyone out there knows better, then lets hear it

 

[proengineer]

I have got the answer:

Copy the whole surface and give it a color. Repeat this again. Call tthe two surfaces in the family table and suppress on of them to get the desired sesults. Amish Bhushan Goel
Engineer
Hitech e Soft
amg@hitechesoft.com

 

[proengineer]

I have got the answer:

Copy the whole surface and give it a color. Repeat this again. Call tthe two surfaces in the family table and suppress on of them to get the desired results. Amish Bhushan Goel
Engineer
Hitech e Soft
amg@hitechesoft.com