I have a metal piece put on the bottom of a shoe that first needs to be coated with a material that would be able to stand up to the abrasive use. I was thinking of the material used for in line or skateboard wheels. Not sure if this material will adhere to metal. Your comments appreciated.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Coating Material for abrasive use? 2
- Thread starter James54
- Start date
-
1
- #2
-
1
- #3
corrosionman
Mechanical
Polyurethane can be made in a wide range of hardnesses and can be very good for abrasion resistance but is practically impossible to stick onto anything.
Rubber is somewhat lower down the resistance scale but better to stick on. it all depends on what you are trying to dp.
regards CM
Rubber is somewhat lower down the resistance scale but better to stick on. it all depends on what you are trying to dp.
regards CM
- Status
Similar threads
- Question
- Locked
- Question