Circular saw design help needed please...

[cabellos]

Hi,

Im lost as to how i should design the bearing housing on the circular saw i am designing. From given dimensions i have so far created the saw, shaft, 2 bearings and v-belt pulley. But i need to put this all together now with the use of designing washers, and bearing housing etc. I really could do with some help so please provide e-mail address so i can send what I have completed so far.

Thanks

 

[MBarone]

Send em on over Mbarone@mgmbrakes.com. Lets see what you've got

 

[robertl]

If you want to send your initial drawings / sketches to me I will gladly help in any way I can.

35 years experience as toolmaker / designer in the water pump field.

robertl@rock.com

Robert Larson
Australia

 

[frederic]

send me the files and i'll see what i can do

frederic_vandenplas@hotmail.com

 

[jaco@alliedfc.co.za]

Sounds Interresting

Send me the stuff that You have. I would like to look at it and help out.

 

[habbe]

I do what I can, to help you man! We had a similar work some month ago!
My email-adress is alexander.harbrecht@gmail.com