exploding a design

[bixwaltg]

Hy everyone, I am leaning to use Autodesk Inventor and in creating a piece of furniture I got stuck. I am creating a furniture through a solid by cutting out edges and partitions and extrude through, to make the hollow section. nows comes to seperate the parts I am stuck. I realise I should of done it through assembly but I guess I learn my lesson from now on. But in the mean time is there any way I can explode the parts so they all can be seperate? I have attached a picture of what I am doing. Please help. thanks in advance.

 

[dstrausser]

If those are all separate features I think you are stuck with what you have. You need to create each part as a part and then create an assembly and assemble all the parts into the assembly.

It will explode on its own. Only when you least want it to.

 

[Cadasio]

I'm not the best Inventor user, but I think you should be able to split it into a multi-body part? Check the official Inventor Multibody support page, you may find it useful - " Use the Split command with the Split Solid option to create separate bodies in a part file. "

If you get it sorted and intend to show the assembly procedure, then check out Cadasio