I am new to SolidWorks, and made this half of a hood for a baja car I am building. I can't figure out how to mirror it to make it complete. The loft will not work if the profile sketches include both halves. I cannot create the loft with open sketches either, using thin feature in loft. Maybe I am missing something obvious, but would be very grateful for help.
Eng-Tips is the largest forum for Engineering Professionals on the Internet.
Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!
-
Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Can't mirror a feature, please help
- Thread starter dslalone
- Start date
SolidWorksEngineer
Mechanical
Maybe this tutorial help -
SolidWorksEngineer
SolidWorksEngineer
Can you post the SW file so we can take a look at it?
It is possible that the face that is supposed to be the middle of the hood isn't exactly square/perpendicular anymore. Possibly, during the sweep it twisted ever so slightly so it is the tiniest bit skewed from the true mid-plane.
Then, when it tries to mirror, it can't figure it out how to handle it.
If you can post the SW file, it would be much easier to see exactly what is happening.
It is possible that the face that is supposed to be the middle of the hood isn't exactly square/perpendicular anymore. Possibly, during the sweep it twisted ever so slightly so it is the tiniest bit skewed from the true mid-plane.
Then, when it tries to mirror, it can't figure it out how to handle it.
If you can post the SW file, it would be much easier to see exactly what is happening.
CorBlimeyLimey
Mechanical
Try creating the part as a surface instead of a thin solid.
- Thread starter
- #6
- Status
Similar threads
- Question