Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

broken view dimension

Status
Not open for further replies.

movia

Mechanical
Jul 19, 2007
59
hi guys,

When i was trying to dimenion a view with the broken view the dimension was getting modified, Can any of you guys suggest how can i maintain the original dimension even after breaking the view without using a fake dimension.

thanks in advance
 
Replies continue below

Recommended for you

What version of Catia you are using?

I remember to seeing this if the dimension was attached to a view axis (h- or v-axis) instead of geometry.
 
Are you using intersection point creation if you are don't. Using intersection points across a break will give you the 2D distance
 
i tried with intersectin point also, but the result was the same, i.e dimension was getting modified
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor