Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Bend And Twist Feature help needed

Status
Not open for further replies.

Deon7

Industrial
Joined
Apr 5, 2007
Messages
12
Location
US
I need to flex and twist a sheet metal channel for a helix conveyor I am designing. The geometry needs to also automatically give me the flat pattern of the channel after the solid part is drawn.

How can get the part to retain both the bend feature and the twist feature at the same time and also allow Solidworks to be able to create the flat pattern?

Thanks in advance
Deon7
 
I don't know about "automatically" ... the only way I know to do what you want is to create a configuration where the Flex features are suppressed, and then activate the Flatten tool in that config.

So, one config to show the finished bent and twisted part, and another to show the flat.

[cheers]
SW07-SP3.1
SW06-SP5.1
 
thanks for the configuration advise i really hadnt thought of that (obviously), but is it possible to keep both the bend and twist settings on a single part at the same time. if so i am having trouble identifying how.

again, thanks in advance.
Deon7
 
SWO6
AND LOOKING FOR SW07
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top