Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Bad Performance with new PC 1

Status
Not open for further replies.

ogrecarlo

Automotive
Joined
Aug 2, 2018
Messages
1
Location
IT
Hello everyone, i'm Carlo and i recently refreshed my workstation:

OLD: i7 4790k 32GB RAM DDR3 Quadro k2000
NEW: i7 7820x 32GB RAM DDR4 Quadro k2000

But now i've noticed that: UGS NX 11.0 takes more time for render/export a project than before (I have old values). Is that normal? hyper threading can affect? I need it ON.

Thanks everyone. Carlo
 
Why do you need hyperthreading on? It effectively only gives you 1/2 of your processor to a single-threaded application like NX. What are the processor speeds for the i7-4790k and the i7-7820x? That may be you issue.


"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli
 
Are you also talking about the same NX versions on both PC's?

Ow and it is Siemens NX11 not UGS[lol]

Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2

Building new PLM environment from Scratch using NX11 / TC11
 
The 7820x benchmarks slower than the 4790k for single thread operations.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top