Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ASTM A518

Status
Not open for further replies.

Faisal1984

Chemical
Joined
May 11, 2010
Messages
2
Location
GB
Gentlemen,

I am in the process of performing rough engineering calculations for the design of a sump pump system.
The process fluid is 10% HCL with abbrasive particles of about 10% by weight , the system temperature is about 50 degrees celsius. I did a little research and arrived at the the conclusion that ASTM A518 Gr 2 had the most acceptable rates of corrosion for this type of environment. I would like to go one step further and suggest the type of material specification for the pump impeller, cartridge , casing , bearings for this type of servive . I would much appraciate if you could help me out here.

Cheers
 
Not sure if a metal casing and impeller is really the best choice for HCl. What about plastic or a coating? I would contact a company like Wernert ( and ask them for a quote with material specification.
 
Thanks , unfortunately I have to present this as a presentation for a job interview

I dont think the pump vendor would care much as I am representing myself (Not BP, Aramco , Shell etc) and $$$ are not involved here. I only have the great minds of this fabulous website to help me on my conquest of this somewhat open ended problem.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top