Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ASME standard for Stud bolts intended for use with Flanges

Status
Not open for further replies.
svi

svi

Mechanical
Joined
Aug 1, 2006
Messages
142
Location
AE
thread292-164732


I never realized this until I start to read the description of the B18.2.1

I wonder if someone can clarify what is the intent of B18.31.2 and why ASME B31.3 and B16.5 does not make reference to it?
 
Status
Not open for further replies.

Similar threads

bck2ftr
  • Question Question
ASME B16.9 - factor f for proof test
Replies
3
Views
11K
goutam_freelance
goutam_freelance
Mech_ash19
  • Locked
  • Question Question
ASME VIII-1 UG-44(b) - External Loads on Standard Flange - Analysis Options for Slip-On Flanges
Replies
2
Views
1K
Mech_ash19
Mech_ash19
Drilling Integrity Super.
  • Locked
Formula for Calculating Basic Allowable Stresses in ASME B31.3
Replies
2
Views
5K
Geoff13
Geoff13
T
  • Question Question
Figure 323.2.2-2 (Reduction in Lowest Exemption Temperature for Steels Without Impact Testing) of ASME B31.3
Replies
0
Views
7K
Tommy2025
T
EMANUELE GUERRINI
  • Locked
  • Question Question
ASME I Boiler with 15 PSI Pressure - Can I Use an ASME IV Safety Valve?
Replies
2
Views
881
The Obturator
The Obturator

Part and Inventory Search

Sponsor

Back
Top