Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
ASME B31.3 - 1/2" elbow obtained from bended tube in ASME SB-165 N04400
- Thread starter FPPE
- Start date
LittleInch
Petroleum
It's not a pipeline it's a piece of pipe.
And yes, just bend it over a mandrel. Or pipe bender.
The Iso shows no fitting so the designer thinks it can be bent from a straight piece of pipe on site.
Remember - More details = better answers
Also: If you get a response it's polite to respond to it.
And yes, just bend it over a mandrel. Or pipe bender.
The Iso shows no fitting so the designer thinks it can be bent from a straight piece of pipe on site.
Remember - More details = better answers
Also: If you get a response it's polite to respond to it.
EdStainless
Materials
If you bend on site, then you should UT check the thickness of the outside of the bend and measure the external ovality of the bend.
There are limits on both of these.
= = = = = = = = = = = = = = = = = = = =
P.E. Metallurgy, consulting work welcomed
There are limits on both of these.
= = = = = = = = = = = = = = = = = = = =
P.E. Metallurgy, consulting work welcomed
- Thread starter
- #4
- Status
Similar threads
- Locked
- Question
- Locked
