I'm located in the U.S. & am designing a control system to AS requirements. Incoming voltage is 690 VAC, 50 Hz. Per spec. HRC fuses are required. I need a fusible disconnect switch & fuses for the power section. Can anyone recommend a suitable switch & fuse mfr.? Fuses will also be required for the VFD & step-down transformer primary. Also while I'm at it, can anyone tell me where to find a 690/120 transformer, around 375 VA? Mfr. & P/N's would be appreciated. Thanks very much for your help.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
AS Fusing Requirements
- Thread starter audios
- Start date
Similar threads
- Locked
- Question
- Question
- Locked
- Question