Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

AS 5532 Manufacturing requirements for single point anchor device used for harness based work...

Status
Not open for further replies.
ShawThing

ShawThing

Structural
Joined
Aug 17, 2017
Messages
46
Location
AU
Hi All
Is anyone familiar with this code and whether the rated loads nominated within are required to be factored up for design or adopted as specified?
Regards
 
Sort by date Sort by votes
Status
Not open for further replies.

Similar threads

bugbus
  • Locked
  • Question Question
Calculating characteristic strengths based on test data
Replies
5
Views
6K
PersonalProfile
PersonalProfile
bugbus
  • Locked
  • Question Question
High strength reinforcement - AS 3600 vs AS 5100.5
Replies
2
Views
3K
bugbus
bugbus
bugbus
  • Locked
  • Question Question
Plate washers for oversize/slotted holes
Replies
7
Views
7K
PersonalProfile
PersonalProfile
Tomfh
  • Question Question
Revised internal pressure calculation in AS/NZS 1170.2:2021 Part 2
2
Replies
29
Views
29K
rowingengineer
rowingengineer
Rav01
  • Locked
  • Question Question
AS 3600 Cl 10.8 Transmission of Axial Force through floor systems
Replies
10
Views
2K
li0ngalahad
li0ngalahad

Part and Inventory Search

Sponsor

Back
Top