Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Applied force
- Thread starter Senad83
- Start date
You have to request the output of the concentrated forces (CF) for the step you want the plot...which I think is selected by default.
Then in the visualization module you can create an XY Data based on applied the concentrated force. You have to select the node where CF was applied.
Visualization Module->Tools Menu->XY Data->Create->
Source="Odb field output"
Position="Unique nodal"
Check "CF Point Loads".
Supply the node where the force was applied in the "Elements/Nodes" tab.
Best.
Then in the visualization module you can create an XY Data based on applied the concentrated force. You have to select the node where CF was applied.
Visualization Module->Tools Menu->XY Data->Create->
Source="Odb field output"
Position="Unique nodal"
Check "CF Point Loads".
Supply the node where the force was applied in the "Elements/Nodes" tab.
Best.
- Status
Similar threads
- Locked
- Question
