Vesselgeek
Mechanical
Does compress check anchor bolts for wind or seismic shear? There is no input for anchor bolt allowable shear stress and I don't see the calculation in the reports.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Anchor Bolt Shear Design
- Thread starter Vesselgeek
- Start date
- Status
Yes, COMPRESS checks this condition.
There actually IS an input on ths saddle design dialog for the anchor bolt allowable shear stress. And the bolt shear stress calculation is shown under the bold caption "Shear stress in anchor bolting"
"Although this forum is monitored by Codeware it is not intended as a venue for technical support and should not be used as the primary means of technical support."
Tom Barsh
Codeware Technical Support
There actually IS an input on ths saddle design dialog for the anchor bolt allowable shear stress. And the bolt shear stress calculation is shown under the bold caption "Shear stress in anchor bolting"
"Although this forum is monitored by Codeware it is not intended as a venue for technical support and should not be used as the primary means of technical support."
Tom Barsh
Codeware Technical Support
- Status
Similar threads