Amada lc2415 laser panel won’t power on

[Dablaingc]

I have an Amada lc2415 Aii and when I start the machine only the Fanuc panel powers up but not the laser panel below the controller.

Sometimes the small segment display powers up for a brief moment and then goes off.

I’ve checked breakers and everything else I could think of but haven’t had any luck.

What board do I need to look into replacing or checking

I’m also getting a air low alarm for the incoming compressed air but I’ve varied I have correct pressure and can’t get it to clear

 

[LASERNINJA]

Behind the machine, Down by the CNC breaker, open the two panels. Inside the one on the right are yellow boxes with a dark gray front. On the bottom of one of those boxes are little green fuses. Check the resistance on those and see if they are blown.

 

[Bluces]

This requires you to check one by one, from the laser control board to the sensor. You need a professional inspection, You can contact us YiHai Laser; we have been engaged in the laser industry