Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Amada FOM-4222 Laser Gas Pressure Alarm

Status
Not open for further replies.

evans1089

Mechanical
Jan 5, 2015
68
Good morning, it's too early to call Amada so I thought I'd ask here first.

So i do the same procedure everymorning wityh switching on the machine. This morning I turn the laser key on, and after about 5 seconds, The laser gas pressure alarm comes up.
Now before anyone asks, Yes there is some in the bottle. Any ideas? There is no alarm code to cross reference to in the books.

Waiting to give them a call around 8 when they get to work..
 
Replies continue below

Recommended for you

You may have to try start it again so when the laser gas pressure alarm comes on you have to check a few things. It sounds like one of your fans on the power supplies or matching box is bad so when the alarm comes on pull the main panel and look for an alarm. You also need to pull the panels and check your fans because one might be locked up or spinning slow so spin them by hand.
 
Do not reset the alarm because the red light on the bad power supply will disappear when you clear the alarm.
 
I did eventually thanks.
Turns out to be a dodgy bottle of laser gas.
The mixtures must have been wrong that we received.

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor