Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Aligning cross section sheets in Geopak
- Thread starter AJgeo
- Start date
AJgeo,
Under your sheet run you will need to set your bottom dimension. If you are using V8 look under Margins and Spacing. However if you are using Microstation J or Geopak 2001 Under Cross Section Sheets go to Vert Clear Zone.
Hope this helps.
Regards,
Namdac
Under your sheet run you will need to set your bottom dimension. If you are using V8 look under Margins and Spacing. However if you are using Microstation J or Geopak 2001 Under Cross Section Sheets go to Vert Clear Zone.
Hope this helps.
Regards,
Namdac
- Status
Similar threads
- Locked
- Question
- Locked
- Question