Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Advice is Required || ASME BPVC Section I Design Software

Status
Not open for further replies.
abuanaselmasry

abuanaselmasry

Mechanical
Joined
Sep 27, 2009
Messages
36
Location
SA
I'm currently looking for a software which can perform the design calculation for the drums fabricated per Section I. I'm still surprised that PVElite and COMPRESS doesn't provide this service.

Looking for your helpful replies.

Regards,
M.Salaheldin
Static Equipment Mechanical Design Engineer
 
Status
Not open for further replies.

Similar threads

timsch
  • Question Question
Question of scope of ASME BPVC SECTION IX
Replies
1
Views
9K
DekDee
DekDee
R
  • Question Question
Exclusion From the Scope of ASME BPVC VIII-1 - water-based solution
Replies
4
Views
6K
goutam_freelance
goutam_freelance
MhmdNfri
  • Question Question
ASME Sec. I / NDT / PW-11 / Table PW-11
Replies
2
Views
471
goutam_freelance
goutam_freelance
victor6397
  • Locked
  • Question Question
Fatigue analysis for C95800 in ASME BPVC Sec VIII div.2
Replies
1
Views
666
TGS4
TGS4
engineer0
  • Question Question
ASME B31.8 vs 49 CFR 192 Subpart D - Design of Pipeline Components
Replies
1
Views
7K
A.egis
A.egis

Part and Inventory Search

Sponsor

Back
Top