jerzy
Mechanical
- Aug 26, 2001
- 68
I am working with a client who has taken in-house about 15 molds that had been built and run off shore. They have 100 mm locating rings; his presses have 4.000 locating holes in the platen. The rings vary from simple types to more complex recessed sprue, three-plate types. These molds will be set up infrequently for short runs. Has anyone any ideas short of remaking all the rings that would enable them to be centered in the platens? Has anyone tried wrapping shim stock around an undersize ring and fastening it somehow
(adhesive or welding)?
Changing the platen hole size ring does not appear to be very easy (presses are very old).
Thank you
Jerzy
(adhesive or welding)?
Changing the platen hole size ring does not appear to be very easy (presses are very old).
Thank you
Jerzy