I am using a Dionex DX-600 for low level transition metal analysis and am having problems obtaining consistent results in the low ppb range. I have tried acidifying and non-acidifying my samples and have actually obtained higher results for the non-acidified samples which goes against what I expected. Does anyone know why this may be?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
accurate detection of low levels of copper in stator water
- Thread starter w0046477
- Start date
Similar threads
- Locked
- Question
