in drafting you can use the Coordinate table and give the Axis system you want as reference for the XYZ values.
if you don't use any you will get part coordinate system, if you use the axis used by the previous designer you should get the same values.
if you want to rebuild the axis used for the table please follow the steps:
create lineZ point1 point4
create planeXY normal to lineZ at point1
create projectP4 of point4 on planeXY
centered on point1 on planeXY, create circle1 radius = point4.X
centered on projectP4 on planexy create circle2 radius = point4.Y
create circle intersections i1,i2
create axis origine on point1
Z direction define by point4 (check invert as point4.Z <0 )
now you have to define X direction by selecting i1
check point coord in new axissystem, if not good, define X direction selecting i2
have fun
Eric N.
indocti discant et ament meminisse periti