Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

2D Analysis with Workbench 13

Status
Not open for further replies.

davidrdguez

Mechanical
Joined
Apr 24, 2010
Messages
59
Location
DE
Hi everyone!

I have a problem to be solved with long sheets and rubbers. They all have the same length so I think it is better doing a 2D simulations.

I'm using Ansys Workbench in the version 13.

In the version 11, the one I used to learn Ansys, there was an option in the project window to choose "Analysis type"and one could choose between 2D or 3D

But in Ansys 13 since they changed all the project management I don't know how to do a 2D study.

Does anyone know how to do it?

Thank you!

Regards,
 
I already found it. right click properties and a new panel pops up.

cheers,
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top