Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

1010 material vs. A50

Status
Not open for further replies.
Greg7152

Greg7152

Industrial
Joined
May 20, 2005
Messages
3
Location
US
Has anyone had any cutting problems btween these two materials in the same thickness? We were having trouble cutting a 1010 .625" thickness an a Trumpf 4000W machine. When we switched to the A50 in the same thickness, it cut fine with the stock tech tables.

Any feed back would be appreciated
 
Status
Not open for further replies.

Similar threads

RPosty
  • Question Question
How to choose correct Beam Splitter for 50/50 output with sealed beam co2 laser? S vs P pole
Replies
3
Views
7K
Bluces
B
Garrett Green
  • Locked
  • Question Question
Mazak Laser having trouble cutting 1/2" Material
Replies
0
Views
1K
Garrett Green
Garrett Green
Thanh Tran
  • Locked
  • Question Question
Cutting galvanized material
Replies
1
Views
203
drossfree
drossfree
Nylli
  • Locked
  • Question Question
LC 3015 F1 NT 4kw laser, problem to cut thicker materials!!
Replies
10
Views
741
Nylli
Nylli
razornick22
  • Locked
  • Question Question
Calculation of Laser Cutting vs Punching
Replies
0
Views
180
razornick22
razornick22

Part and Inventory Search

Sponsor

Back
Top