Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

1010 material vs. A50

Thread starter Greg7152
Start date May 20, 2005

Status: Not open for further replies.

May 20, 2005

Greg7152

Industrial

Has anyone had any cutting problems btween these two materials in the same thickness? We were having trouble cutting a 1010 .625" thickness an a Trumpf 4000W machine. When we switched to the A50 in the same thickness, it cut fine with the stock tech tables.

Any feed back would be appreciated