Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

1/2" Stainless Steel Button Screws

Status
Not open for further replies.
courtnvm

courtnvm

Structural
Jun 28, 2003
81
I am providing structural calculations on a glass guradrail system that is using 1/2" diameter stainless steel button head screws. I was wondering if there is any standard that would give me the typical pullout values and shear values of the screws. I believe the stainless steel grade would be 304 or 316.

Thanks for the advice in advance.

Val

Val Courtney, PE
Optimal Engineering, Inc.
 
Status
Not open for further replies.

Similar threads

MRondini
  • Locked
  • Question
Welding Stainless Steel 310 to 316L
Replies
3
Views
1K
EdStainless
EdStainless
Gears6580
  • Locked
  • Question
Welding SS2205 - Duplex Stainless steel to 316L 1
Replies
9
Views
2K
dik
dik
GTrinh97
  • Locked
  • Question
Screws and Nails
Replies
3
Views
296
3DDave
3DDave
M
  • Locked
  • Question
Bonding to Aluminum and Stainless Steel
Replies
5
Views
810
TugboatEng
TugboatEng
rollingcloud
  • Locked
  • Question
What's the main cause for incomplete silver brazing on stainless steels?
Replies
11
Views
3K
TugboatEng
TugboatEng

Part and Inventory Search

Sponsor

Back
Top Bottom