Recent content by oijammu

Composition of a good PM : he is 25% schooling, 25% experience and 50%(bullshit, able to out shout the other guy)

Check out www.12d.com .u should get all yr queries answered

I use 3d solids for creating buildings, with each element(terrain, excavation, column base, plinth,etc) in a seperate layer.Then any view port can be seen and plotted, by putting of and on relevant layers. for each relevant view you can insert an extra layer for dimensioning. Hope my "greek...

Hi All, Especially 10Gallen I am in Tanzania. My Company has just aquirred 12d and your tip is godsend. In fact check highway engineering forum. My Email is mooslimtj@hotmail.com

Hi Guys, anybody familiar with 12d Model.Available at "www.12d.com". My Company has started recently using this program.It can read dwg files too.

Try copying the entire BoQ(Description,units & rates) to resource sheet and change type to materials, and go to ghant chart and allocate qty in resource allocation.Even Priliminaries & General can be allocated this way.Woa you will not believe your eyes!

We normally use heavy duty masking tape between the two surfaces. It works especially between Aluminium roof sheeting and MS Z-purlins. I used it in abuilding in 1984, and no corrosion has not been detected todate

After the welding, we usually use a zinc paint called "GALVAFROID"

In my 22 years construction experience, I agree with MMOT & Bluesman. 7 day strength should be 2/3 of 28 day value

How can I get mass properties of walls drawn in Architectual Desktop, so as to get them into tag properties

You want the wooden external surface for aesthetic purposes only! Why dont you infill it with reinforced concrete.

Thanks guys both of your ideas work Mooslim [8-)]

I can produce very exciting structures in 3d shade mode, but only get 3d Wire frames in printout.SOS guys! I need to it to bamboozle my Boss and his clients

1]For Quick Guesstimates of Quotations for any work,Rate=Material Cost X 4.Prilimininaries =Materials cost x 1. 2]A good Engineer=25% of schooling + 25% practical experience + 50% be able to out-bluff the other person! From Tanzania

I believe that the reinforcement is designed for max moment at centre of span.At the support it is for shear only.So it should not be a big if 'd' is slightly smaller at the support