Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

BradVanasse
  • Locked
  • Question Question
Runout equivalent for a non-cylindrical form
Replies
16
Views
532
pmarc
pmarc
Wunderbear
  • Locked
  • Question Question
Conversion of orthogonal tolerances to round tolerance zones
Replies
2
Views
368
Wunderbear
Wunderbear
AndrewTT
  • Locked
  • Question Question
profile in a general note, used on a casting
Replies
2
Views
88
Belanger
Belanger
swertel
  • Locked
  • Question Question
Interpretation of Surface Finish Symbol - Is Smoother Acceptable?
Replies
3
Views
835
swertel
swertel
dmg33
  • Locked
  • Question Question
Drawing Check Process
Replies
7
Views
2K
KENAT
KENAT
ldffernandes
  • Locked
  • Question Question
Interpretation of a true position geometric tolerance
Replies
14
Views
437
ldffernandes
ldffernandes
gabimo
  • Locked
  • Question Question
GD&T quiz (job pre-req. test) – part 2
Replies
4
Views
122
pmarc
pmarc
gabimo
  • Locked
  • Question Question
GD&T quiz (job pre-req. test) – part 1
Replies
11
Views
298
Belanger
Belanger
Shawn Pete
  • Locked
  • Question Question
Your thoughts on dimensions with a non-specified tolerance.
Replies
2
Views
165
Belanger
Belanger
gabimo
  • Locked
  • Question Question
fig 4-16 -Y14.5-2009 and datum feature C -as tertiary
Replies
12
Views
224
3DDave
3DDave
cbrf23
  • Locked
  • Question Question
Position of a basic feature?
Replies
6
Views
288
mkcski
mkcski
BamblingBambler
  • Locked
  • Question Question
When should I use the FRTZF tolerance frame?
Replies
3
Views
195
gabimo
gabimo
ModulusCT
  • Locked
  • Question Question
Squareness Tolerance
Replies
12
Views
2K
ModulusCT
ModulusCT
QE Mike
  • Locked
  • Question Question
Help on positional inspection method
Replies
8
Views
145
pylfrm
pylfrm
mkcski
  • Locked
  • Question Question
Y14.5 Certification Renewal
Replies
12
Views
437
Belanger
Belanger
psiwak
  • Locked
  • Question Question
Parallelism in ISO12129 without base indication
Replies
4
Views
187
CheckerHater
CheckerHater
gabimo
  • Locked
  • Question Question
"half" dimensions
Replies
15
Views
665
greenimi
greenimi
dgallup
  • Locked
  • Question Question
Color specifications
Replies
19
Views
803
pmarc
pmarc
hydronicengr
  • Locked
  • Question Question
Datum Selection for Block Supported by 3 Pins
Replies
19
Views
495
CheckerHater
CheckerHater
R1chJC
  • Locked
  • Question Question
Confusion over Datum choice on Positional Tol.
2
Replies
26
Views
933
mkcski
mkcski
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top