Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

VitorSantiago
  • Locked
  • Question Question
Profile of a line with datum reference
Replies
5
Views
327
Belanger
Belanger
Bogdan.
  • Locked
  • Question Question
Good GD&T representation
Replies
7
Views
325
Bogdan.
Bogdan.
phamENG
  • Locked
  • Question Question
Surface Roughness and Electrical Connectivity
Replies
2
Views
160
phamENG
phamENG
Einzel
  • Locked
  • Question Question
Calculating TP of datum pattern?
Replies
15
Views
516
chez311
chez311
Jacob Cheverie
  • Locked
  • Question Question
Y14.5.1
Replies
6
Views
180
Jacob Cheverie
Jacob Cheverie
ivanmr4
  • Locked
  • Question Question
Wall thickness control
Replies
4
Views
920
drawoh
drawoh
Kedu
  • Locked
  • Question Question
Slot / snap-ring dimension
Replies
6
Views
334
Kedu
Kedu
E26
  • Locked
  • Question Question
Unknown Mystery Symbol on Drawing
Replies
2
Views
92
E26
E26
JavadM
  • Locked
  • Question Question
any standard for Drafter, checker and approve duties and responsibilities?
Replies
6
Views
278
JavadM
JavadM
310toumad
  • Locked
  • Question Question
Basic dimensions of hole pattern
Replies
3
Views
2K
pmarc
pmarc
njm789
  • Locked
  • Question Question
Side View Dimensioning of Interupted Feature of Size/Chamfers/etc
Replies
2
Views
219
ewh
ewh
DGN1975
  • Locked
  • Question Question
secondary plane/ line alignment when primary is axis/ center point
Replies
9
Views
404
Burunduk
Burunduk
Babu96
  • Locked
  • Question Question
Shall we consider a profile tolerance with datum referenced at mmc as additional tol in stackup anal
2
Replies
21
Views
878
pmarc
pmarc
ctopher
  • Locked
  • Helpful tip Helpful tip
GD&T helpful link
Replies
6
Views
195
dtmbiz
dtmbiz
Mateus_R
  • Locked
  • Question Question
Geometric Tolerances - reference values for different mechanical process
Replies
4
Views
292
mkcski
mkcski
randy64
  • Locked
  • Question Question
Close fitting dowel restricting pos tol of clearance holes?
Replies
3
Views
247
mkcski
mkcski
njm789
  • Locked
  • Question Question
GDT Counterbored Slots
Replies
2
Views
791
njm789
njm789
Babu96
  • Locked
  • Question Question
Calculating virtual condition??
Replies
7
Views
559
chez311
chez311
njm789
  • Locked
  • Question Question
GDT V Block Tolerancing
Replies
10
Views
1K
3DDave
3DDave
dtmbiz
  • Locked
  • Question Question
The "purpose" for definition of FOS and AME (ASME Y14.5 2009) Conical /Tapered features
5 6 7
Replies
122
Views
4K
Burunduk
Burunduk
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top