Good morning, everyone. Can anyone point me in the direction of a good resource relating surface roughness and/or topology to electrical contact performance? Are there maximum/minimum roughness characteristics that are recommended for mated parts conducting electricity? Do these change with voltage/amperage? If you think this would be better received/responded to in a different forum, please point me in the right direction. Thanks.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Surface Roughness and Electrical Connectivity
- Thread starter phamENG
- Start date
- Status
Similar threads
- Question
- Locked
- Question
- Locked
- Question