Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

dingy2
  • Locked
  • Question Question
What is the Best Stack Up Analysis Book Out There??
Replies
6
Views
1K
Tunalover
Tunalover
draftsman101
  • Locked
  • Question Question
Thread Call Out
Replies
8
Views
2K
draftsman101
draftsman101
azazf
  • Locked
  • Question Question
Detail View
Replies
5
Views
216
ctopher
ctopher
jpswiontek
  • Locked
  • Question Question
Novice looking for constructive criticism on runout and position
Replies
17
Views
285
fcsuper
fcsuper
MattBD
  • Locked
  • Question Question
Using hole pattern as orienting datum feature
Replies
2
Views
236
CheckerRon
CheckerRon
draftsman101
  • Locked
  • Question Question
Plotting to Scale for Templates
Replies
6
Views
189
ewh
ewh
don0000
  • Locked
  • Question Question
Can a cylindrical feature with draft be a datum?
Replies
4
Views
268
dingy2
dingy2
allenchu
  • Locked
  • Question Question
How to Gage R&R Flatness?
Replies
2
Views
364
dingy2
dingy2
BMDesign
  • Locked
  • Question Question
Specifying GD&T on a Hex machined nut
Replies
13
Views
505
ewh
ewh
beebo666
  • Locked
  • Question Question
deveation question
2 3
Replies
48
Views
938
ja500
ja500
MattBD
  • Locked
  • Question Question
help in defining a surface
Replies
4
Views
179
ctopher
ctopher
aardvarkdw
  • Locked
  • Question Question
Using ASME Y14.41 and ASME Y14.5
Replies
19
Views
907
KENAT
KENAT
GeorgeEllwood
  • Locked
  • Question Question
Good book on GD&T
Replies
1
Views
85
KENAT
KENAT
MattBD
  • Locked
  • Question Question
Inspection symbols with GD&T
Replies
7
Views
814
JohnNabors
JohnNabors
bobbydee
  • Locked
  • Question Question
Projected tolerance zone
Replies
8
Views
271
ringman
ringman
humanbone
  • Locked
  • Question Question
Postion Tolerance on a Theaded Hole?
Replies
15
Views
490
musashi99
musashi99
designmr
  • Locked
  • Question Question
Assembly Drawing, LEVEL 3
2 3
Replies
51
Views
2K
KENAT
KENAT
designmr
  • Locked
  • Question Question
FLATNESS in ASSEMBLIES
Replies
4
Views
474
designmr
designmr
don0000
  • Locked
  • Question Question
gear pitch cone as a datum
Replies
1
Views
172
drawoh
drawoh
cwdaniel
  • Locked
  • Question Question
Can symmetry be implied without GD&T?
2
Replies
39
Views
2K
drawoh
drawoh
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top