Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

draftsmandon
  • Locked
  • Question Question
Redesigning part - BOM change
Replies
10
Views
502
fcsuper
fcsuper
aenman
  • Locked
  • Question Question
Hole defined as datum feature
Replies
8
Views
507
palecactus
palecactus
uGlay
  • Locked
  • Question Question
Indicating concentricity on a over-molded part
Replies
5
Views
182
palecactus
palecactus
eci1990
  • Locked
  • Question Question
viewing hidden lines on imported 2d files
Replies
2
Views
203
palecactus
palecactus
palecactus
  • Locked
  • Question Question
decimal places and ordinate dims
Replies
3
Views
431
palecactus
palecactus
matalik
  • Locked
  • Question Question
position tol of tapped hole
2
Replies
27
Views
1K
Keveo
Keveo
richg1
  • Locked
  • Question Question
Tolerance of Features located by a Centreline
Replies
6
Views
1K
richg1
richg1
AliThePro
  • Locked
  • Question Question
Virtual condition - Resultant condition
Replies
1
Views
170
powerhound
powerhound
Brandy7
  • Locked
  • Question Question
Datum Shift on a Restrained GD&T Part
Replies
4
Views
209
axym
axym
JoeBlock
  • Locked
  • Question Question
No [ - C - ] datum on engine bracket?
Replies
4
Views
178
dingy2
dingy2
Joshmo
  • Locked
  • Question Question
Assembly Drawing BOM Change Question
Replies
6
Views
300
ctopher
ctopher
radracer
  • Locked
  • Question Question
proper temperature for inspection. where? why?
Replies
3
Views
875
Heckler
Heckler
MarkUMSU
  • Locked
  • Question Question
Becoming better at tolerancing
Replies
9
Views
254
KENAT
KENAT
mopar4u
  • Locked
  • Question Question
Is this correct GD&T?
Replies
16
Views
386
tk369
tk369
cadfreak
  • Locked
  • Question Question
Tolerance Stack Up Software
Replies
5
Views
679
TomGDandT
TomGDandT
ImnotfromMars
  • Locked
  • Question Question
Using 3D Model Geometry
Replies
18
Views
566
thundair
thundair
powerhound
  • Locked
  • Question Question
Datum shift
Replies
2
Views
115
tgwow
tgwow
par1
  • Locked
  • Question Question
position tolerance
Replies
5
Views
203
dingy2
dingy2
Foodcutter
  • Locked
  • Question Question
Is there a Standard for markups?
Replies
12
Views
854
CheckerRon
CheckerRon
jlazzara
  • Locked
  • Question Question
Use of "STK" for stock size callouts
Replies
11
Views
2K
Tunalover
Tunalover
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top