Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

tuggertoo
  • Locked
  • Question Question
NCS Standards
Replies
5
Views
153
KENAT
KENAT
WHITMIREGT
  • Locked
  • Question Question
COUNTERBORE
2 3
Replies
53
Views
1K
KENAT
KENAT
KENAT
  • Locked
  • Question Question
Drawing Checker/Approver Qualifications
2
Replies
39
Views
1K
KENAT
KENAT
sbozy25
  • Locked
  • Question Question
Circular runout measuring argument
Replies
10
Views
232
dingy2
dingy2
KENAT
  • Locked
  • Question Question
Drawing standards only for Military work
2 3
Replies
43
Views
995
KENAT
KENAT
UMDpru
  • Locked
  • Question Question
GD&T Onsite Instruction
Replies
12
Views
187
GMIracing
GMIracing
KimBellingrath
  • Locked
  • Question Question
Definition of North Elevation
Replies
5
Views
615
ewh
ewh
aardvarkdw
  • Locked
  • Question Question
Hex Note?
Replies
7
Views
522
CoryPad
CoryPad
bryjarmoc
  • Locked
  • Question Question
Circularity tolerance (out of round condition)
Replies
9
Views
692
powerhound
powerhound
KENAT
  • Locked
  • Question Question
Kelvin Mount Positional Tolerance
Replies
3
Views
139
Standing
Standing
cmwatson78
  • Locked
  • Question Question
significant figures
Replies
4
Views
231
TheTick
TheTick
allenchu
  • Locked
  • Question Question
What is the difference between Runout and Concentricity???
Replies
7
Views
829
KENAT
KENAT
trickysheep
  • Locked
  • Question Question
Sharp edge tolerance?
2
Replies
25
Views
2K
israelkk
israelkk
clydetheglide
  • Locked
  • Question Question
Radius/Chamfer callout
Replies
14
Views
706
aardvarkdw
aardvarkdw
KENAT
  • Locked
  • Question Question
Frequency/Level of Tol analysis
Replies
5
Views
158
KENAT
KENAT
AmeristarQA
  • Locked
  • Question Question
Measurement Scanners
Replies
2
Views
149
markn325e
markn325e
joebk
  • Locked
  • Question Question
coaxiality overboard?
Replies
11
Views
386
KENAT
KENAT
JsTyLz
  • Locked
  • Question Question
ASME Y14.5-1994 Assumed 90 degree angle on the print
Replies
3
Views
655
JsTyLz
JsTyLz
lmcchesney
  • Locked
  • Question Question
Material Condition in Multiple Single Segment Position Tolerances
Replies
2
Views
108
ctopher
ctopher
joebk
  • Locked
  • Question Question
datum consumption
Replies
8
Views
212
dingy2
dingy2
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top