Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

ImnotfromMars
  • Locked
  • Question Question
Contribution MMC on Datum
Replies
7
Views
283
ImnotfromMars
ImnotfromMars
ringman
  • Locked
  • Question Question
Orientation of hole pattern relative to a slot
Replies
9
Views
283
powerhound
powerhound
JamesDWeed
  • Locked
  • Question Question
composite & two-single feature frame position tolerance
2
Replies
21
Views
1K
PaulJackson
PaulJackson
jszymkowski
  • Locked
  • Question Question
Dimensioning displaced state vs. free state of elastomer product
Replies
1
Views
120
drawoh
drawoh
KENAT
  • Locked
  • Question Question
Going crazy on profile of surface?
Replies
5
Views
114
KENAT
KENAT
hkumar8028
  • Locked
  • Question Question
Dimensional Tolerance stack-up Softwares (commercial)
Replies
1
Views
89
PaulJackson
PaulJackson
mactuck
  • Locked
  • Question Question
Perpendicularity of a frame
Replies
8
Views
177
ewh
ewh
CondensedMatter
  • Locked
  • Question Question
Free online reference for Y14.5 ?
Replies
4
Views
148
WHITMIREGT
WHITMIREGT
rmaki
  • Locked
  • Question Question
GD&T Corrective Action.
2
Replies
23
Views
607
KENAT
KENAT
Parsnip
  • Locked
  • Question Question
Tolerances of different process
Replies
7
Views
238
KENAT
KENAT
KENAT
  • Locked
  • Question Question
standard drawing scales
2
Replies
30
Views
2K
btrueblood
btrueblood
powerhound
  • Locked
  • Question Question
Rectangular Tolerance zones
Replies
5
Views
403
KENAT
KENAT
KENAT
  • Locked
  • Question Question
specifying minimum surface roughness
Replies
7
Views
346
KENAT
KENAT
KENAT
  • Locked
  • Question Question
DIAMETERS SHOWN IN LINE NOT NECESSARILY COAXIAL
2
Replies
35
Views
447
vc66
vc66
trickysheep
  • Locked
  • Question Question
Angular True Position?
2
Replies
21
Views
920
ringman
ringman
joebk
  • Locked
  • Question Question
datum casting vs machining
Replies
5
Views
541
121560
121560
i2xtreme
  • Locked
  • Question Question
Repetitive Features
Replies
13
Views
819
Heckler
Heckler
JV1
  • Locked
  • Question Question
Tolerances and decimal places
Replies
19
Views
2K
KENAT
KENAT
CheckerRon
  • Locked
  • Question Question
USE OF "ALL AROUND" CIRCLE SYMBOL
Replies
7
Views
483
CheckerRon
CheckerRon
FullerMTU
  • Locked
  • Question Question
Diameter callout on drawing
Replies
17
Views
534
weavedreamer
weavedreamer
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top