Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

vc66
  • Locked
  • Question Question
Tolerance on Arc Length
Replies
4
Views
306
vc66
vc66
RobNOK
  • Locked
  • Question Question
position of a Surface Point
Replies
10
Views
382
RobNOK
RobNOK
WHITMIREGT
  • Locked
  • Question Question
Hi everybody, I would like to know
Replies
5
Views
124
KENAT
KENAT
KENAT
  • Locked
  • Question Question
Dimensioning method
Replies
1
Views
111
fcsuper
fcsuper
Heckler
  • Locked
  • Helpful tip Helpful tip
ASME Approved Abbreviations
Replies
4
Views
252
ctopher
ctopher
WHITMIREGT
  • Locked
  • Question Question
Hi Folks Figure 6-49 of the Y14.5
Replies
5
Views
135
PaulJackson
PaulJackson
ewh
  • Locked
  • Question Question
Hello all. I have been seeing this
Replies
9
Views
119
ewh
ewh
ryandias
  • Locked
  • Question Question
drawing size
Replies
5
Views
170
KENAT
KENAT
pdybeck
  • Locked
  • Question Question
Material not being supplied with certs - general market trend?
Replies
12
Views
274
wes616
wes616
LONDONDERRY
  • Locked
  • Question Question
What is the correct designator for calling out ISO fasteners
Replies
5
Views
425
Heckler
Heckler
vc66
  • Locked
  • Question Question
Hexagonal Callout on Drawing
Replies
4
Views
3K
CoryPad
CoryPad
danondabass
  • Locked
  • Question Question
manufacturing capabilities by feature type?
Replies
8
Views
121
MikeHalloran
MikeHalloran
KENAT
  • Locked
  • Question Question
Statistical Tolerance Question
Replies
4
Views
138
KENAT
KENAT
dcbobhcco
  • Locked
  • Question Question
true position slide ruler
Replies
6
Views
200
vigildesign
vigildesign
KENAT
  • Locked
  • Question Question
Drafting Zone Accounts
Replies
2
Views
84
KENAT
KENAT
KENAT
  • Locked
  • Question Question
tolerance analysis to ISO 8015 & 2768 part 1 (again!)
Replies
4
Views
789
KENAT
KENAT
Brandy7
  • Locked
  • Question Question
Where in ASME 14.5 does it state we can add & subtract Basic Dim's.
2
Replies
20
Views
499
Brandy7
Brandy7
KENAT
  • Locked
  • Question Question
Tolerance analysis ISO2768
Replies
14
Views
487
KENAT
KENAT
WHITMIREGT
  • Locked
  • Helpful tip Helpful tip
Using acronyms
Replies
13
Views
370
prohammy
prohammy
allenchu
  • Locked
  • Question Question
RUNOUT Measuring Method for a Driving Shaft
Replies
5
Views
591
powerhound
powerhound
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top