Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

JLang17
  • Locked
  • Question Question
Bonus Tolerance at RFS
Replies
5
Views
224
JLang17
JLang17
KENAT
  • Locked
  • Question Question
Unusual application of Datum Target Areas
Replies
3
Views
148
CheckerRon
CheckerRon
RunningFree
  • Locked
  • Question Question
Referencing other drawings within a drawing
Replies
5
Views
797
drawoh
drawoh
DesignBiz
  • Locked
  • Question Question
default profile callout
2
Replies
20
Views
853
fcsuper
fcsuper
DesignBiz
  • Locked
  • Question Question
Simultaneous requirement
2 3 4
Replies
62
Views
2K
DesignBiz
DesignBiz
SeasonLee
  • Locked
  • Question Question
Drawing conversion from plus minus to comply with GDT Std
2
Replies
27
Views
1K
DesignBiz
DesignBiz
JLang17
  • Locked
  • Question Question
Profile and Datum Question
2 3
Replies
43
Views
1K
KENAT
KENAT
KENAT
  • Locked
  • Question Question
Composite Positional Tolerancing & Simultaneous Requirement RFS
Replies
17
Views
607
KENAT
KENAT
KENAT
  • Locked
  • Question Question
Composite or 2 single segment FCF to control perpendicularity of hole
Replies
10
Views
209
KENAT
KENAT
KENAT
  • Locked
  • Question Question
Appendix B4 ASME Y14.5M-1994 Fixed Fastener Positional Tolerance Calc.
2
Replies
34
Views
745
fcsuper
fcsuper
KayHH
  • Locked
  • Question Question
Profile, where datums are specified
Replies
3
Views
98
KayHH
KayHH
PRuggiero
  • Locked
  • Question Question
Tolerance Analysis
Replies
11
Views
259
drawoh
drawoh
LADO
  • Locked
  • Question Question
Rev Letters
Replies
8
Views
263
fcsuper
fcsuper
Porknar
  • Locked
  • Question Question
Checking Concentricity and TIR
2
Replies
22
Views
2K
MechNorth
MechNorth
pacific123
  • Locked
  • Question Question
Best way to learn GD&T???
Replies
17
Views
633
KENAT
KENAT
PROEGUY
  • Locked
  • Question Question
mil spec ????
Replies
4
Views
761
PROEGUY
PROEGUY
moldshields
  • Locked
  • Question Question
I need help with a dimension of MMC of .000
Replies
7
Views
230
DesignBiz
DesignBiz
paramathma
  • Locked
  • Question Question
Chamfer
Replies
5
Views
382
CorBlimeyLimey
CorBlimeyLimey
rmaki
  • Locked
  • Question Question
Systemic
Replies
3
Views
108
KENAT
KENAT
rmaki
  • Locked
  • Question Question
New ASME Y14.5 2009 Std.
Replies
14
Views
363
ctopher
ctopher
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top