Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

maheshh
  • Locked
  • Question Question
Parallelism versus flatness
Replies
11
Views
414
vc66
vc66
Dave K
  • Locked
  • Question Question
Abbreviation for "location"
Replies
12
Views
1K
CheckerRon
CheckerRon
JLang17
  • Locked
  • Question Question
Datum needed?
Replies
9
Views
255
KENAT
KENAT
TANDQBPOII
  • Locked
  • Question Question
Surface profile at MMC?
Replies
12
Views
691
TANDQBPOII
TANDQBPOII
lastviking
  • Locked
  • Question Question
alignment between hole and slot with unilateral tolerances
Replies
3
Views
208
KENAT
KENAT
CheckerRon
  • Locked
  • Question Question
Expanded use of ALL AROUND Symbol
2
Replies
27
Views
2K
CheckerRon
CheckerRon
nrostrander
  • Locked
  • Question Question
Dimensioning stock extrusions
Replies
19
Views
338
SeasonLee
SeasonLee
JLang17
  • Locked
  • Question Question
Profile Control of Datum
Replies
5
Views
176
KENAT
KENAT
ModulusCT
  • Locked
  • Question Question
Proposal for adopting ASME Y14.5M-1994
Replies
14
Views
211
KENAT
KENAT
drdherl
  • Locked
  • Question Question
Has anyone ever used a "design parameter drawing"?
Replies
5
Views
209
EdMcCabe
EdMcCabe
JLang17
  • Locked
  • Question Question
Datum Pattern Dimensioning
Replies
3
Views
244
axym
axym
ImnotfromMars
  • Locked
  • Question Question
Included angle
Replies
4
Views
713
pierdesign
pierdesign
renasis
  • Locked
  • Question Question
Assembly Drawings - Arrow tip for part callout on the outline of part
Replies
17
Views
1K
dgallup
dgallup
NoWittyHandle
  • Locked
  • Question Question
Simplified Layer and Lineweight Standards for Civil Eng.
Replies
1
Views
129
SeasonLee
SeasonLee
Jaydenn
  • Locked
  • Question Question
True Position using Bolt circle and Angle
Replies
14
Views
1K
axym
axym
JLang17
  • Locked
  • Question Question
Datum Pattern Callouts
Replies
5
Views
177
ewh
ewh
thecadman2
  • Locked
  • Question Question
Tolerance zone from respective datums
Replies
3
Views
88
axym
axym
TXspace
  • Locked
  • Question Question
Thread Note
2
Replies
25
Views
1K
cadman1964
cadman1964
hurley710
  • Locked
  • Question Question
NX and ASME Y14.5-2009 - Dimensioning & Tolerancing
Replies
3
Views
148
fcsuper
fcsuper
cmlpetro
  • Locked
  • Question Question
single line iso's
Replies
1
Views
104
ctopher
ctopher
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top