Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

JASON8102
  • Locked
  • Question
Drafting Standards,BOM Standards, and P/N standards 3
Replies
12
Views
669
fcsuper
fcsuper
ImnotfromMars
  • Locked
  • Question
Orientation question
Replies
3
Views
99
drawoh
drawoh
ImnotfromMars
  • Locked
  • Question
Profile -Chained Dimensions- Stack up 5
Replies
8
Views
240
ImnotfromMars
ImnotfromMars
JASON8102
  • Locked
  • Question
Bill Of Material Standard for Drawings 4
2
Replies
25
Views
761
ewh
ewh
docgeoffyjones
  • Locked
  • Question
Tolerance combinations in ISO BS8888
Replies
5
Views
251
docgeoffyjones
docgeoffyjones
Godsown1
  • Locked
  • Question
Where is "Bolt Circle" listed as BC in the ASME 14.5 spec.? 2
Replies
1
Views
647
KENAT
KENAT
Tunalover
  • Locked
  • Question
Floating fastener formula for unequal distributions 3
Replies
7
Views
749
pmarc
pmarc
fcsuper
  • Locked
  • Question
THRU, THRU ALL and Continuous Feature 1
2
Replies
34
Views
3K
KENAT
KENAT
flash3780
  • Locked
  • Question
Fractional vs Decimal Screw Thread Callout
Replies
10
Views
608
fcsuper
fcsuper
robertadc
  • Locked
  • Question
Unkown symbol on drawing
2
Replies
31
Views
562
mfgenggear
mfgenggear
bryjarmoc
  • Locked
  • Question
Concetricity with .002 of T.I.R. 5
Replies
17
Views
654
fsincox
fsincox
Tizbass
  • Locked
  • Question
Perpendicularity to a pitch diameter 1
Replies
6
Views
296
fsincox
fsincox
flash3780
  • Locked
  • Question
View Orientation Question 2
Replies
16
Views
760
KENAT
KENAT
TZellers
  • Locked
  • Question
Apparently, not your typical TITLE BLOCK question...
Replies
15
Views
334
Joshmo
Joshmo
ajn22
  • Locked
  • Question
Section View
Replies
5
Views
100
flash3780
flash3780
bryjarmoc
  • Locked
  • Question
Implied Centerline 2
Replies
18
Views
582
DustyRhodes
DustyRhodes
Tizbass
  • Locked
  • Question
Flatness call-out
Replies
4
Views
370
Tizbass
Tizbass
jumacao
  • Locked
  • Question
how to determine tolerance? 1
Replies
2
Views
111
PeterStock
PeterStock
janandk
  • Locked
  • Question
Coplanar surfaces using profile callout 2
Replies
12
Views
711
fcsuper
fcsuper
qcgoofyfoot
  • Locked
  • Question
Profile and position callout 1
2
Replies
37
Views
599
MechNorth
MechNorth
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top Bottom