Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

JASON8102
  • Locked
  • Question Question
Bill Of Material Standard for Drawings
2
Replies
25
Views
1K
ewh
ewh
docgeoffyjones
  • Locked
  • Question Question
Tolerance combinations in ISO BS8888
Replies
5
Views
319
docgeoffyjones
docgeoffyjones
Godsown1
  • Locked
  • Question Question
Where is "Bolt Circle" listed as BC in the ASME 14.5 spec.?
Replies
1
Views
767
KENAT
KENAT
Tunalover
  • Locked
  • Question Question
Floating fastener formula for unequal distributions
Replies
7
Views
975
pmarc
pmarc
fcsuper
  • Locked
  • Question Question
THRU, THRU ALL and Continuous Feature
2
Replies
34
Views
4K
KENAT
KENAT
flash3780
  • Locked
  • Question Question
Fractional vs Decimal Screw Thread Callout
Replies
10
Views
720
fcsuper
fcsuper
robertadc
  • Locked
  • Question Question
Unkown symbol on drawing
2
Replies
31
Views
788
mfgenggear
mfgenggear
bryjarmoc
  • Locked
  • Question Question
Concetricity with .002 of T.I.R.
Replies
17
Views
936
fsincox
fsincox
Tizbass
  • Locked
  • Question Question
Perpendicularity to a pitch diameter
Replies
6
Views
379
fsincox
fsincox
flash3780
  • Locked
  • Question Question
View Orientation Question
Replies
16
Views
983
KENAT
KENAT
TZellers
  • Locked
  • Question Question
Apparently, not your typical TITLE BLOCK question...
Replies
15
Views
466
Joshmo
Joshmo
ajn22
  • Locked
  • Question Question
Section View
Replies
5
Views
113
flash3780
flash3780
bryjarmoc
  • Locked
  • Question Question
Implied Centerline
Replies
18
Views
758
DustyRhodes
DustyRhodes
Tizbass
  • Locked
  • Question Question
Flatness call-out
Replies
4
Views
513
Tizbass
Tizbass
jumacao
  • Locked
  • Question Question
how to determine tolerance?
Replies
2
Views
136
PeterStock
PeterStock
janandk
  • Locked
  • Question Question
Coplanar surfaces using profile callout
Replies
12
Views
847
fcsuper
fcsuper
qcgoofyfoot
  • Locked
  • Question Question
Profile and position callout
2
Replies
37
Views
874
MechNorth
MechNorth
macduff
  • Locked
  • Question Question
Contolling Electronic Cad Data
2
Replies
31
Views
1K
fcsuper
fcsuper
Belanger
  • Locked
  • Question Question
Tangent Plane
Replies
8
Views
474
ringman1
ringman1
fsincox
  • Locked
  • Question Question
The Politics Of GD&T
2 3
Replies
53
Views
1K
MechNorth
MechNorth
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top